Výzkum lokálního smrštění u biopolymerů PLA a PLLA

Abstract
Disertační práce se zabývá výzkumem lokálního smrštění biopolymerů v závislosti na vybraných vstřikovacích (rychlostních, tlakových a teplotních) parametrech procesu (dotlak, teplota taveniny, vstřikovací rychlost) a také na geometrii zkušebního tělesa (tloušťka stěny výstřiku). Lokální smrštění je experimentálně zkoumáno v různé vzdálenosti od vtokového ústí (vliv dráhy tečení) na speciální testovací obdélníkové destičce. Pro výzkum byly použity dva biodegradibilní materiály PLA a PLLA, které byly porovnány a vyhodnoceny pomocí statistických a experimentálních metod. Pro porovnání získaných výsledků a verifikací simulačních výstupů byla provedena analýza tečení.
The dissertation thesis deals with research of local shrinkage of biopolymers depending on selected injection speed, pressure and temperature parameters of the process (packing pressure, melt temperature, injection rate) as well as the geometry of the test part (wall thickness of injection part). Local shrinkage is experimentally examined at a different distance from the inlet (influence of the flow path) on a special test rectangular plate. Two PLA and PLLA biodegradable materials were used for the research, which were compared and evaluated using statistical and experimental methods. A moldflow analysis was performed to compare the obtained results and verify the simulation outputs.
Description
Subject(s)
PLA, PLLA, smrštění, simulace, PLA, PLLA, shrinkage, simulation
Citation
ISSN
ISBN
Collections