Chlazení a tepelná bilance vysokotlakých slévárenských forem
Loading...
Date
2022-06-15
Authors
Journal Title
Journal ISSN
Volume Title
Publisher
Abstract
Diplomová práce se zabývá řešením výroby odlitku skříně převodovky ze slitiny AlSi9Cu3 vysokotlakým způsobem. V teoretické části je proveden rozbor procesu výroby odlitků vysokotlakým litím, ošetření líce formy nátěry a nástřiky, je uveden rozbor vad. Základem teoretické části diplomové práce je uveden výpočet tepelné bilance vyráběných odlitků. Experimentální část práce je zaměřena na konkrétní výrobu odlitků skříně převodovky, kdy líc vysokotlaké formy byl ošetřen mikro postřikem. Byl proveden výpočet tepelné bilance formy při použití mikro postřiku. Dále bylo provedeno hodnocení vad odlitků.
The diploma thesis deals with the solution of the production of the gearbox housing casting for AlSi9Cu3 alloys in a high-pressure manner. The theoretical part is an analysis of the production process of high-pressure die castings, face treatment, coatings and spraying, there is an analysis of defects. The basis of the theoretical part of the diploma thesis is the calculation of the heat balance of produced castings.The experimental part of the work is focused on the specific production of gearbox housing castings, where the face of the high-pressure mould was treated by micro-spraying. The heat balance of the mould was calculated using micro-spraying. Furthermore, an evaluation of casting defects was performed.
The diploma thesis deals with the solution of the production of the gearbox housing casting for AlSi9Cu3 alloys in a high-pressure manner. The theoretical part is an analysis of the production process of high-pressure die castings, face treatment, coatings and spraying, there is an analysis of defects. The basis of the theoretical part of the diploma thesis is the calculation of the heat balance of produced castings.The experimental part of the work is focused on the specific production of gearbox housing castings, where the face of the high-pressure mould was treated by micro-spraying. The heat balance of the mould was calculated using micro-spraying. Furthermore, an evaluation of casting defects was performed.
Description
Subject(s)
vysokotlaké lítí, odlitek, mikro-postřik líce formy, tepelná bilance, vady odlitků, high pressure die casting, casting, micro-spraying face mould, heat balance of mould, casting defects